Skip to content
High Open Electronics & Screen

Nozzle temperature errors from hotend wiring or toolhead board

Prints stop with "nozzle temperature is abnormal" (open circuit) or 0300-8008 errors, sometimes with the temperature dropping a few layers into a print or the thermistor reading wildly high. Several owners replaced the hotend heating assembly, some more than once, and still had the error, which points to the connectors, the toolhead cable or the toolhead (TH) board. Reports span late 2024 into early 2025.

What fixes it

Reseat the thermistor and heater connectors carefully and check for pinched wires. If a new hotend heating assembly does not help, contact Bambu support. A replacement TH board fixed it for one owner but not for another, so results are mixed.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment