Skip to content
Low Open Extrusion & Hotend

Z-banding that cleaning and tuning do not fix

A few A1 Mini owners see irregular horizontal banding on walls after 2 to 3 cm of height, sometimes with under-extrusion, even after cleaning, lubrication, belt tensioning and drying filament. In one case Bambu support sent a replacement extruder under warranty, which fixed it. Reports are from late 2024 and early 2025.

What fixes it

Rule out filament and slicer causes (one user fixed similar banding by switching the wall generator from Arachne to Classic). If it persists, open a ticket; a replacement extruder resolved it for one owner.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment