Skip to content
Low Open Firmware & Software

Firmware authorization blocks third-party printer control

Bambu's authorization control firmware (announced January 2025, X1 series first, P and A series later) requires approved software to start prints and control the printer. On updated firmware, third-party tools such as OrcaSlicer's direct send and print-farm services lose control unless the printer is switched to LAN Only mode with Developer Mode. Status reporting and SD card printing still work.

What fixes it

Enable LAN Only mode plus Developer Mode to restore third-party control, use Bambu Connect, or stay on older firmware.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment