Tool pick-up and docking failures stop prints
Printer Hub collects a few Creator 5 Pro reports of prints stopping at a tool change because a toolhead would not pick up, dock or return to its slot, shown as errors in the E0127 to E0146 range. Missing dock or carriage magnets are among the listed causes, and one owner's tool sat higher in the dock than the others so it could never be picked up. Tom's Hardware found the docking reliable in its testing.
What fixes it
Check each tool sits in its own slot, clean and check the magnets, home and retry, and update firmware (1.7.8 improved the error prompts). Printer Hub says a tool that fails from day one is a warranty case.
Log in to confirm this happens to you
0 owners confirmed