Skip to content
Low Open Firmware & Software

PETG forces chamber into heating mode, aux fan locked on

When printing PETG, the P2S switches its airflow to chamber heating mode and runs the aux fan around 50% regardless of fan settings. Owners report overhang sag, warmer chambers, warping and clogs. One Bambu developer said heating mode for PETG is by design; another suggested chamber temperature mode.

What fixes it

Community workarounds: set the PETG filament softening temperature below 50 °C so the printer picks cooling mode, or add cooling-mode commands to filament start G-code.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment