Skip to content
High Open Extrusion & Hotend

Filament blob encases hotend and breaks thermistor wires

When a print detaches, molten filament can build up and wrap the nozzle and heater block into a solid blob. The exposed thermistor and heater wires on the A1 series hotend are easily torn by the blob or while picking it off, leaving a hotend that will not heat. Owners describe replacing the hotend heating assembly; one owner who did so still had no heat and suspects the toolhead board.

What fixes it

Owners suggest heating the nozzle (a soldering iron or careful heat gun) and removing the blob slowly, keeping clear of the wires. Broken wiring means replacing the hotend heating assembly, which owners put at about $20 and 30 minutes.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment