Large purge waste with third-party filament
Flush volumes on the Creator 5 Pro are tuned for Flashforge's own filament, so other brands purge far more than a toolchanger should. Tom's Hardware got a 44 g purge block for a 33 g model on defaults, and loading filament also dumped a lot of material inside the printer until firmware 1.9.4 (July 2026) moved the drop point.
What fixes it
Lower flush volumes by hand in the slicer's flush matrix and enable flushing into infill or the object. Update to firmware 1.9.4 or later so load purges drop at the rear.
Sources
Log in to confirm this happens to you
0 owners confirmed