Skip to content
Medium Open Slicing & Profiles

Gaps and under-extrusion on stock profiles

Early H2C owners found gaps between lines on top and bottom layers, between walls and infill, and on first layers with default Bambu and third-party PLA profiles. Raising flow about 3% or running manual flow calibration helped some. Bambu developers acknowledged the issue on GitHub and said a slicer mitigation would come first, with a full fix later.

What fixes it

Run manual flow calibration (an owner notes auto flow calibration only sets pressure advance), raise flow ratio a few percent, and increase infill/wall overlap. Results are mixed.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment