Skip to content
Medium Open Bed Adhesion & Leveling

Gaps in first layer from Z-offset and probing

Many P2S owners see gaps between first-layer lines and weak adhesion. Attention focused on the P2S start G-code using a positive Z-offset where other Bambu printers use negative ones, plus nozzle residue affecting the eddy-current probe. A Bambu developer said the issue is related to the printer and asked for logs; a later config update changed offsets for hot beds and added an extra nozzle wipe, with mixed results.

What fixes it

Update to firmware 01.02 or later and use the manual Z-offset or First Layer Quality calibration. Some owners set a negative Z-offset in start G-code or raise first-layer flow.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment