Skip to content
High Open Extrusion & Hotend

Hotend leaks, clogs and short hotend life

Owners report hotends leaking at the heater-to-heatbreak joint, clogs with PETG, and an extruder that clicks and slips after 10 to 15 minutes. One owner went through four hotends in a month and another replaces one about every 40 hours. One owner found heat shrink on the heater wires too short, leaving bare wire that could short.

What fixes it

Owners clear clogs and replace hotends; some convert to the K2 Plus hotend using community instructions, though one still had sagging prints after. One owner fixed exposed heater wire with electrical tape or silicone gel. Replacement parts can take a week to a month to arrive.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment