Skip to content
Medium Open Slicing & Profiles

Large purge waste with third-party filament

Flush volumes on the Creator 5 are tuned for Flashforge's own filament, so other brands purge far more than a toolchanger should. Tom's Hardware got a 44 g purge block for a 33 g model on defaults, and loading filament also dumped a lot of material inside the printer until firmware 1.9.4 (July 2026) moved the drop point.

What fixes it

Lower flush volumes by hand in the slicer's flush matrix and enable flushing into infill or the object. Update to firmware 1.9.4 or later so load purges drop at the rear.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment