Skip to content
High Open Electronics & Screen

CR Touch errors and nozzle crashing into the bed while leveling

Owners report CR Touch sensor errors at boot or during auto-leveling, sometimes with a long beep or boot loop, and in other cases the nozzle keeps pushing down into the bed during leveling, which can dent or burn the bed surface. It has been reported on new units out of the box and on printers a few months old. Three threads on Creality's forum cover roughly 20 to 24 owners.

What fixes it

Owners often clear it by freeing a sticking probe pin, and two fixed a binding plunger with a small shim or spacer. Others fixed it by cleaning debris from under the bed or moving bed wiring that touched the heater; one owner suspects the hotend cover pinches the CR Touch cable. When that fails, Creality support has sent replacement CR Touch probes or strain gauges under warranty. Results are mixed and several threads end unresolved.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment