Skip to content

Newer version available: the Bambu Lab P2S.

High Open Electronics & Screen

Hotend will not heat or reports abnormal nozzle temperature

P1S owners report the hotend reading 0 or throwing nozzle temperature errors, often after clearing a clog or reseating the hotend. Fixes vary: one owner found a torn TH board FPC cable, while others replaced the hotend, TH board and cables without success. Two owners said rolling back to older firmware (one named 1.07, from 1.08) got them printing again.

What fixes it

Reseat hotend connectors and inspect the TH board FPC cable for tears. Some owners recovered by downgrading firmware; others needed toolhead parts from support. Results are mixed.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment