Skip to content
High Open Electronics & Screen

Heatbed signal cable breaks after a few hundred hours

The thin 6-pin heatbed signal cable runs through tight bends at the rear Z mount with little strain relief. Owners report it breaking after a few hundred hours, causing force sensor errors, homing failures or lost bed temperature readings. Bambu's wiki has a replacement guide and notes the cable routing was later changed.

What fixes it

Replace the heatbed signal cable (inexpensive spare part, wiki guide available) and route it without sharp bends.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment