Skip to content
Medium Open Extrusion & Hotend

Extruder and hotend clogs that stop extrusion

Owners report filament jamming in the hotend or short PTFE tube and prints that stop extruding mid-job; most reports come from K1 Max owners, and a Creality moderator says the K1 and K1 Max use the same extruder. One K1 owner's extruder motor would not turn even after several replacement extruders and motors, and a community member called it a known fault on some early extruders. Heat creep from printing PLA with the lid closed is a suspected factor.

What fixes it

Owners suggest printing PLA with the lid off, lowering the retraction temperature, clearing jams by removing the extruder and pushing the blockage through a hot nozzle, and replacing a deformed PTFE tube. One K1 owner says Creality support was sending a replacement extruder and motor.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment