Creality K1 known issues
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Low Built-in camera not detected or keeps disconnecting
The web interface or Creality Print shows the camera as not connected or 'rejected our connection'. Rebooting brings it back for a while. A firmware update to 1.3.3.5 fixed it for one owner, while others still had the problem on 1.3.3.46.
What fixes it: Power cycle the printer and update firmware. A replacement camera seemed to fix it for one owner but not another, and reseating the camera cable did not help those who tried.
From public reports: forum.creality.com, forum.creality.com · Confirm or add a fix
-
Medium Extruder and hotend clogs that stop extrusion
Owners report filament jamming in the hotend or short PTFE tube and prints that stop extruding mid-job; most reports come from K1 Max owners, and a Creality moderator says the K1 and K1 Max use the same extruder. One K1 owner's extruder motor would not turn even after several replacement extruders and motors, and a community member called it a known fault on some early extruders. Heat creep from printing PLA with the lid closed is a suspected factor.
What fixes it: Owners suggest printing PLA with the lid off, lowering the retraction temperature, clearing jams by removing the extruder and pushing the blockage through a hot nozzle, and replacing a deformed PTFE tube. One K1 owner says Creality support was sending a replacement extruder and motor.
From public reports: forum.creality.com, forum.creality.com, forum.creality.com · Confirm or add a fix
-
Low Rear exhaust fan runs even when turned off
The rear chamber fan spins during prints even when disabled in Creality Print or on the screen, and one owner saw it start whenever the chamber hit 35 °C. One owner was on firmware 1.3.3.36.
What fixes it: A factory reset after a firmware update fixed it for one owner but not another. One user suggests setting the fan's minimum temperature through Fluidd on a rooted printer.
From public reports: forum.creality.com · Confirm or add a fix
-
Low Start G-code nozzle wipe scratches the rear of the PEI plate
Before each print the nozzle moves to the back edge of the plate for a 'wiping nozzle' step and drags across it. One K1 owner reported dents and a scratch about 30 mm long, and a K1 Max owner confirmed the same wipe spot. It sits outside the normal print area, so other owners see it as cosmetic.
What fixes it: Owners point to a printed nozzle wiper add-on with a silicone strip, which needs printer.cfg changes on a rooted printer, or a K1C-style silicone wiper plate mod. No one reported results.
From public reports: forum.creality.com · Confirm or add a fix