Skip to content

Newer version available: the Creality Ender-3 V4.

Medium Open Bed Adhesion & Leveling

Auto Z offset leaves first layer too close or too high

Owners report the automatic Z offset putting the nozzle nearly on the bed, or well above it unless auto calibration runs before every print. A Creality staff member said in April 2024 that the cause had been found and a software fix was coming. Reports continued after the May 2024 firmware.

What fixes it

Update firmware first (1.2.1.13 lists improved auto leveling and first layers, though reports continued after it). Owners otherwise adjust Z offset on the screen or store an offset in printer.cfg under prtouch_v2; note a self-level comments that line out again.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment