Large ABS and nylon parts warp without a heated chamber
The Q2C drops the Q2's active chamber heater, so large ABS and nylon parts can lift and delaminate, especially in cool rooms. Small ABS and ASA parts print fine, and one review rates ASA as good in the enclosure. This is a design limit rather than a defect.
What fixes it
Preheat the bed for 10 to 15 minutes with the door closed and use a wide brim and glue stick (roundup advice). For regular nylon or large ABS work, reviewers point to the Q2 instead.
Sources
Log in to confirm this happens to you
0 owners confirmed