QIDI Q2C known issues
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Medium QIDI Box multicolor feeding is unreliable
A known-issues roundup says the optional QIDI Box on the Q2C has a high-friction filament path and a bowden bend at the extruder that make color changes unreliable. Tom's Hardware's review of the closely related Q2 Combo found a sharp 90-degree bend into the extruder and could not reliably feed more than one filament; QIDI told them it was working on the issues.
What fixes it: Tom's Hardware's printed riser let the Box feed one filament on the Q2, but not four. No fix from QIDI has been confirmed.
From public reports: tomshardware.com, printer-hub.com · Confirm or add a fix
-
Medium Large ABS and nylon parts warp without a heated chamber
The Q2C drops the Q2's active chamber heater, so large ABS and nylon parts can lift and delaminate, especially in cool rooms. Small ABS and ASA parts print fine, and one review rates ASA as good in the enclosure. This is a design limit rather than a defect.
What fixes it: Preheat the bed for 10 to 15 minutes with the door closed and use a wide brim and glue stick (roundup advice). For regular nylon or large ABS work, reviewers point to the Q2 instead.
From public reports: 3dtechvalley.com, printer-hub.com · Confirm or add a fix
-
Low Wi-Fi and network dropouts on early units
A review notes that a small number of users reported firmware connectivity issues and network dropouts on early production units. A known-issues roundup for the Q2 and Q2C lists flaky Wi-Fi on early batches.
What fixes it: Update the firmware after setup (back up configs first, since the update script makes no backups) or use Ethernet.
From public reports: 3dtechvalley.com, printer-hub.com · Confirm or add a fix