Nozzle drags or grinds across top surfaces and infill
Several owners in a long forum thread report the nozzle scraping through top layers and infill on flat parts, leaving rough surfaces. One owner says support told them it was normal behavior, and support also had them raise one motor's current, which only partly helped. One owner fixed it by reseating a loose lower toolchanger panel and another by rebuilding a belt tensioner with a stripped screw.
What fixes it
Snapmaker staff suggest flow calibration, 3 to 5 top layers, and slower top surfaces. Owners report fixes from reseating the lower toolchanger panel and repairing belt tensioners; results are mixed. Open a support ticket if it continues.
Log in to confirm this happens to you
0 owners confirmed