Skip to content
Medium Open Bed Adhesion & Leveling

Auto Z offset leaves the first layer too high or shifts

After auto calibration the first layer often sits too high, so it does not stick and gets dragged around, and the offset can shift between prints. Owners also saw a firmware update reset the Z offset, followed by adhesion problems.

What fixes it

Lower the Z offset by about 0.10 to 0.15 mm while watching a wide skirt, and recheck it after every firmware update. A factory reset cleared a firmware mismatch loop for one owner.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment