Skip to content
Low Open Firmware & Software

False Filament Track Switch mismatch warning

When sending a job from Bambu Studio, many owners get a warning that the installed Filament Track Switch does not match the sliced file, including owners who never installed the accessory. Re-slicing does not reliably clear it. Owners report prints continue normally, but it can show on almost every print and Bambu has not explained it.

What fixes it

Owners mostly ignore it. Running AMS auto-detection on the printer and then syncing and re-slicing in Studio clears it for one owner some of the time; results are mixed.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment