Skip to content
Low Open Electronics & Screen

Filament runout sensor gives false alarms

Prints pause with 'ran out of filament' even though filament is loaded, at random points. One owner sees the opposite, a sensor that never triggers, and a replacement sensor did not change it. A factory reset and firmware update did not fix the false alarms for another owner.

What fixes it

Unplugging the runout sensor lets prints finish, at the cost of runout detection. Unplugging it is also a suggested test for wiring versus mainboard faults.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment