Skip to content
Medium Open Extrusion & Hotend

Extruder jams and clogs that stop filament feeding

New and older K1C units stop extruding, with the gears caked in filament, burnt residue in the hotend, or a knocking extruder. Causes owners found include clogs, filament tangles, suspected wet filament, a hotend assembled too high, and in one case frayed hotend wiring where Creality supplied a replacement hotend. Printing PLA too hot can lead to heat creep.

What fixes it

Clear the nozzle at about 240 to 250 °C with the cleaning tool, or remove the extruder and push a rod through the hot nozzle. Dry the filament, check the hotend wiring, and make sure the hotend is seated correctly after any rebuild.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment