Creality K1C known issues
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Medium K1C 2025 cannot use the CFS upgrade kit
Owners of the K1C 2025 who bought the CFS upgrade kit found the mainboard rejects the CFS firmware, and one found the toolhead board lacks the cutter and runout connector. Owners relay Creality support saying the K1C and K1C 2025 are different models and that the 2025 model will be adapted to a CFS-C later. Owners say the 2025 revision is marked 'K1C 2025' on the rear nameplate.
What fixes it: Check the nameplate before buying the CFS kit. Creality offered one owner a replacement toolhead board and hotend base, and at least one owner returned the CFS.
From public reports: forum.creality.com, forum.creality.com · Confirm or add a fix
-
Medium Extruder jams and clogs that stop filament feeding
New and older K1C units stop extruding, with the gears caked in filament, burnt residue in the hotend, or a knocking extruder. Causes owners found include clogs, filament tangles, suspected wet filament, a hotend assembled too high, and in one case frayed hotend wiring where Creality supplied a replacement hotend. Printing PLA too hot can lead to heat creep.
What fixes it: Clear the nozzle at about 240 to 250 °C with the cleaning tool, or remove the extruder and push a rod through the hot nozzle. Dry the filament, check the hotend wiring, and make sure the hotend is seated correctly after any rebuild.
From public reports: forum.creality.com, forum.creality.com · Confirm or add a fix
-
Low K1C 2025 revision ships without root access
The K1C 2025 hardware revision removes the root access option the original K1C offered, which owners say they need for OrcaSlicer device control, bed mesh viewing, config tuning and Spoolman. A Creality employee said in December 2025 that R&D was doing a technical evaluation, with no promise or date. Some owners say they only learned of the change after buying.
What fixes it: No official fix. One user says Creality Print 7 added Fluidd support, and community members have shared an unofficial root exploit, which another user could not get working and which Creality does not support.
From public reports: forum.creality.com, forum.creality.com · Confirm or add a fix
-
Low Power supply fan keeps running when idle
The PSU fan runs for hours after prints finish, or starts at idle and never stops, and one owner describes it as grindy. Reports span late 2024 to early 2026, mostly on the K1C. Creality has not replied in the thread.
What fixes it: No confirmed fix. Owners have suggested a smart plug to cut power after prints, with no results reported; disengaging the steppers did not help one owner.
From public reports: forum.creality.com · Confirm or add a fix
-
Medium CFS cutter jam error TC2841 blocks printing
With the CFS fitted, the printer stops with 'cutter issue, cutter might be jammed' and will not continue. One owner fixed it by fully seating the extruder and another by switching filament; one found a short on the cutter sensor circuit. Creality support has sent at least one replacement cutter.
What fixes it: Pull the extruder and slide the cutter by hand to find binding, fully reseat the extruder, then run Self Check with cutter calibration, which worked for one owner. Switching filament brand fixed it for another. Loosening the XY belts slightly has been suggested, with no results reported.
From public reports: forum.creality.com · Confirm or add a fix