Hotend clogs and hotends that fail after a few weeks
Owners describe filament jamming in the hotend or the short PTFE tube below the extruder, prints stopping after the first layer, and hotends needing replacement every few weeks. One owner said failed prints gum up the hotend and break a wire. Printing PLA with the lid on and a warm chamber is a suspected factor. A Creality moderator says the K1 and K1 Max use the same extruder.
What fixes it
Owners suggest printing PLA with the glass lid off, lowering the retraction temperature, and replacing a deformed PTFE tube with one cut to the same length. When reseating a hotend, make sure it sits at the right height and use thermal paste on the heatsink; some owners prefer the red silicone sock hotend.
Log in to confirm this happens to you
0 owners confirmed