Skip to content

Newer version available: the Creality SPARKX i8.

Medium Open Extrusion & Hotend

CFS Lite does not fully retract at color changes

Owners find filament is not pulled back to the CFS Lite at a color change, or a swap cuts three times then fails with TR2963. One owner relays a Creality livestream saying the CFS Lite only retracts clear of the hotend by design, so part of this may be expected behavior.

What fixes it

One owner starts a load, waits for retraction to begin, then pulls the old filament out by hand, and restarts if the light flashes red. For TR2963, pressing OK then Proceed completes the swap but wastes filament. No official fix.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment