Skip to content
High Open Electronics & Screen

First self-check or auto-leveling fails with unknown Key errors

Mostly on new units, the initial self-check or auto-leveling stops with errors such as Key 3000, Key 2401 or Key 2022, sometimes with the print head shaking against the frame. About 20 owners reported it, most around the late 2023 launch, and no single cause was found.

What fixes it

Things that worked for some owners: setting the voltage switch to match the mains supply, tightening the X and Y belts, leveling the gantry, reseating cables, and a factory reset. A replacement Z-level board and sensor from Creality fixed it for two owners, while a replacement CR Touch alone did not help one. One owner's replacement printer failed the same way.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment