Skip to content
Medium Open Bed Adhesion & Leveling

Z offset not saved reliably or drifts

Reviewers and owners report that the Neptune 4 Max does not always keep the saved nozzle-to-bed distance, so first layers change between prints. Tom's Hardware had to set the Z height through Klipper's web interface by hand on the 4 Max. Probe thermal drift, over-tight wheels or Z nut screws, and bed springs that sag over time add to it.

What fixes it

Calibrate Z offset with the bed heat-soaked (about 20 minutes at 60 °C), set it only from the printer's screen, check the eccentric wheels and Z nut screws are not over-tightened, and confirm the mesh profile loads in the start G-code.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment