Skip to content
Medium Open Motion System

Toolhead pick-up and parking failures

Owners report toolheads failing to latch, release, or dock, mostly during first calibration, homing, or job start, with toolhead parking failure error codes. Snapmaker's troubleshooting page lists debris on the homing contact surfaces, an inner panel lifted when installing the filament holder, nozzle scraping and incorrect docking position as causes. Owners also suspect belt tension. Snapmaker added toolhead coordinate adjustment in firmware 0.9.4 and homing calibration in 1.0.0 to address these failures.

What fixes it

Update firmware, clean the homing contact areas, and check that no inner panel is lifted (Snapmaker). Owners also re-run belt tensioning slowly several times and adjust pick/park coordinates; results are mixed, and some owners still had failures afterward. Contact support if it persists.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment