Skip to content
Medium Open Electronics & Screen

Leveling sensor anomaly errors during homing or calibration

The printer reports a leveling sensor anomaly and the Z axis stays at the bottom or fails partway through calibration. One owner got replacement strain gauges and a mainboard from Creality without curing it; another replaced the strain gauges and heated bed. Two cases began after adding an enclosure or camera.

What fixes it

No confirmed fix. A firmware reflash has been suggested, and a factory reset did not help one owner. Creality support sent one owner strain gauges and a mainboard.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment