Skip to content
High Open Extrusion & Hotend

QIDI Box multicolor feeding is unreliable on the Q2

The filament path from the QIDI Box into the Q2 has a tight hub and a sharp PTFE bend into the extruder, which causes binding and jams. Tom's Hardware could only feed one color reliably, and a second Box sent by QIDI behaved the same. Version 2 of the Box added new entry guides, a buffer and a tube support, but the inlet is still criticized.

What fixes it

Install QIDI's riser (now in the Box accessory kit) to reduce the bend and check PTFE tubes for wear and kinks, though Tom's Hardware found the riser alone did not make multicolor work. If multicolor matters, weigh this before buying the combo.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment