Loud noise on long X-axis moves
Several owners hear a loud rumble or grind during long X-axis travel while short moves are quiet. Prints are usually fine. One owner says Creality support told him the sound is normal and to lubricate the axis; other owners disagree that it is normal.
What fixes it
Owners suggest cleaning and greasing the lower X rod (one owner says the upper bushing is self-lubricating and should not be greased) and backing off overtight bearing set screws. Greasing did not stop the noise for the original poster, and no fix is confirmed. One owner says Creality may replace scored rods or bearings if shown a video.
Sources
Log in to confirm this happens to you
0 owners confirmed