QIDI X-Max 3
No owners yet. Here's everything else.
Replaced by the QIDI Max4.
0 of 5 owners · 5 more and the score goes live.
No longer sold new. Reviews and known issues still apply.
View at QIDI storeOwner reviews 0 Rate it (10 seconds)
Reviewers earn Spools (site points) for any review, good or bad. Spools never change a score.
No owner reviews yet. If you own a X-Max 3, yours will be the first, and it starts this printer's ranking.
Owner wall
Own one? Add yoursNo verified owners yet. Post a photo of yours with your code and be the first on the wall.
Price history
Official US store, checked weeklyNo price history yet.
Known issues 3
Report an issueFrom brand advisories, owner forums and reviews, with sources on each. Newest first. Tap one for what happens and what fixes it.
-
Medium System fails to boot after a bad firmware update
Failed or manual updates can leave the printer showing "the system starts abnormally", a blank screen, or MCU protocol errors, usually after updating Klipper or Moonraker by hand. Recovery can mean reflashing the eMMC.
What fixes it: Only install QIDI's packaged updates from USB. To recover, reinstall QIDI's firmware or reflash the eMMC with QIDI's image (community recovery scripts exist), or replace the eMMC module if that fails.
From public reports: github.com, printer-hub.com · Confirm or add a fix
-
Medium PLA and TPU heat creep clogs in the enclosed chamber
Heat in the closed enclosure softens PLA and TPU in the hotend throat, causing clogs. 3DPrintBeginner says the top cover should always be removed for these materials.
What fixes it: Print PLA and TPU with the top cover removed.
From public reports: 3dprintbeginner.com, printer-hub.com · Confirm or add a fix
-
Low Part cooling covers only part of the bed
There is one part fan on the head and one small auxiliary fan that reaches about 70% of the bed, so big PLA models cool unevenly and overhangs suffer on the far side. The part fan also whines at full speed.
What fixes it: Orient critical overhangs toward the aux fan, slow down, or fit a second side fan or a different duct.
From public reports: 3dprintbeginner.com, printer-hub.com · Confirm or add a fix
Older or fixed issues (2)
-
Medium Early units had a weak bottom frame Fixed
The first 2023 batch had a bottom frame not strong enough for repeatable prints, and QIDI paused sales to fix it. The relaunched version added a stiffer all-metal frame and bottom crossbars.
What fixes it: QIDI revised the frame before relaunch. When buying used, confirm it is a post-relaunch unit.
From public reports: 3dprintbeginner.com, printer-hub.com · Confirm or add a fix
-
Low Chamber heater overshoot trips thermal protection Fixed
The chamber heater uses on/off control, and when pushed toward 70 °C Klipper often triggers its thermal runaway shutdown. QIDI's firmware 4.3.13 limited chamber heating to 65 °C. Owners also report temperature swings that show as wall banding, which the cap does not change.
What fixes it: Update to 4.3.13 or later. For the swings, owners move the chamber sensor off the metal frame or switch the heater to PID control.
From public reports: 3dprintbeginner.com, github.com, printer-hub.com · Confirm or add a fix
Specs
A large-format enclosed CoreXY printer with a heated chamber, replaced by the QIDI Max4. It remains popular with owners printing big parts in ABS, ASA and nylon.