PLA clogs if the chamber runs too hot
Excess chamber heat can soften PLA in the heatbreak and raise clog risk. QIDI's own FAQ says excessive chamber heat could increase the risk of nozzle clogging, and recommends keeping the chamber about 10 °C under the filament's softening point and no higher than 45 °C for PLA.
What fixes it
Keep the chamber at or below 45 °C for PLA (QIDI). Owners open the front door and slide back the lid for PLA and PETG, or use QIDI's optional Polar Cooler extruder cooler; QIDI says chamber heat can be used with most materials once the cooler is fitted.
Sources
Log in to confirm this happens to you
0 owners confirmed