QIDI Max4 known issues
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Medium PLA clogs if the chamber runs too hot
Excess chamber heat can soften PLA in the heatbreak and raise clog risk. QIDI's own FAQ says excessive chamber heat could increase the risk of nozzle clogging, and recommends keeping the chamber about 10 °C under the filament's softening point and no higher than 45 °C for PLA.
What fixes it: Keep the chamber at or below 45 °C for PLA (QIDI). Owners open the front door and slide back the lid for PLA and PETG, or use QIDI's optional Polar Cooler extruder cooler; QIDI says chamber heat can be used with most materials once the cooler is fitted.
From public reports: qidi3d.com, printer-hub.com · Confirm or add a fix
-
Low Loud with the Polar Cooler and QIDI Box running
AndroidPCTV measured about 56 dB normally, 62 dB with the Polar Cooler and 65 dB with the Box. AppleInsider found it fairly quiet without the cooler but would not want it running in a room they work in once the cooler is on.
What fixes it: No fix reported. The extra noise comes from the optional Polar Cooler and QIDI Box.
From public reports: androidpctv.com, appleinsider.com · Confirm or add a fix
-
Low Multicolor prints are slow and wasteful
Single-nozzle color swaps with the QIDI Box add time and purge waste. NikKTech notes multicolor filament waste is still a thing, and AndroidPCTV's three-color test print took 14 hours.
What fixes it: No fix reported in the cited reviews.
From public reports: androidpctv.com, nikktech.com · Confirm or add a fix
-
Low Firmware and software still maturing
Reviewers in 2026 report bugs in QIDI Studio and firmware that occasionally interrupt the workflow; NikKTech could not use timelapse because of them. AndroidPCTV lists firmware and software still being improved as a con.
What fixes it: No specific fix reported in the cited reviews.
From public reports: nikktech.com, androidpctv.com · Confirm or add a fix