Skip to content
High Open Electronics & Screen

Nozzle temperature malfunction errors stop prints

P1 series owners report recurring "nozzle temperature malfunction" or open-circuit errors (0300-8008), sometimes with the hotend unable to hold temperature after about 15 minutes. One confirmed cause was a slightly torn TH board FPC cable on a P1S; other owners replaced the hotend, thermistor and TH board without a lasting fix. Reports run from 2023 into late 2025, including a P1P with about 4,000 hours.

What fixes it

Inspect and reseat hotend connectors and the TH board FPC cable; replacing a torn FPC cable fixed it for one owner. A new TH board helped only temporarily for some. Otherwise open a ticket for toolhead parts. Results are mixed.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment