Bambu Lab P1P known issues
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Low Firmware authorization blocks third-party printer control
Bambu's authorization control firmware requires approved software to start prints and control the printer. On updated P1 firmware, third-party tools that sent jobs or controlled the printer directly stop working unless the printer is put in LAN-only Developer Mode. Status reporting and SD card printing are unaffected.
What fixes it: Enable LAN Only mode plus Developer Mode, use Bambu Connect, or stay on older firmware.
From public reports: blog.bambulab.com, feedback.simplyprint.io · Confirm or add a fix
-
High Nozzle temperature malfunction errors stop prints
P1 series owners report recurring "nozzle temperature malfunction" or open-circuit errors (0300-8008), sometimes with the hotend unable to hold temperature after about 15 minutes. One confirmed cause was a slightly torn TH board FPC cable on a P1S; other owners replaced the hotend, thermistor and TH board without a lasting fix. Reports run from 2023 into late 2025, including a P1P with about 4,000 hours.
What fixes it: Inspect and reseat hotend connectors and the TH board FPC cable; replacing a torn FPC cable fixed it for one owner. A new TH board helped only temporarily for some. Otherwise open a ticket for toolhead parts. Results are mixed.
From public reports: forum.bambulab.com, forum.bambulab.com, forum.bambulab.com, forum.bambulab.com · Confirm or add a fix
-
Low Heat creep clogs with PLA once the P1P is enclosed
The open-frame P1P does not need changes to avoid heat creep, but Bambu's wiki says a P1P fitted with an enclosure should follow the P1S advice for low-temperature filaments. One owner with a cabinet enclosure reported repeated PLA clogs, though they were also printing hotter than usual.
What fixes it: Bambu recommends printing PLA with the front door and/or top cover removed on an enclosed P1P. Owners also suggest lowering nozzle and bed temperature.
From public reports: wiki.bambulab.com, forum.bambulab.com · Confirm or add a fix