Skip to content
Medium Open Extrusion & Hotend

Filament cutter does not fully cut, causing jams and FR2865

The toolhead cutter sometimes leaves filament partly attached or with a melted tip, which jams the extruder or triggers FR2865 (filament failed to exit extruder) at the end of a print. One owner tied it to cutter travel tolerance exposed by newer firmware.

What fixes it

Replace the cutter blade, then run the full calibration including cutter calibration. Some owners fit a printed cutter rod spacer, with mixed results.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment