Creality K2 Plus known issues
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Critical Nozzle drives into the bed during leveling (strain gauge faults)
During pre-print probing, some printers keep raising the bed until it hits the nozzle, or slam the bed repeatedly, then stop with CM2789 or another error. Owners traced it to a failed strain gauge, pinched toolhead wiring, or a damaged extruder board. One owner had bent guides after the extruder hit the bed.
What fixes it: Replacing the strain gauge and fixing pinched toolhead wires worked for one owner; another saw the fault return after about 20 prints with a new strain gauge. A community member suggests sending support a video with the serial number.
From public reports: forum.creality.com, forum.creality.com · Confirm or add a fix
-
High CFS fails to retract or feed filament at color changes
At a color change the filament does not pull back to the CFS, or the new filament never reaches the extruder, and the printer flags a clog or a feed error such as FR2836. It has been reported since late 2024 and was still being reported in 2026. Replacement extruders from Creality did not cure it for at least two owners.
What fixes it: Owners report checking for a missing cutter rod and loose rail screws, clearing metal debris from the cutter magnet (which fixed it for one owner), fitting a printed spacer behind the cutter arm, and reseating the CFS hub as a temporary workaround. Results are mixed and no official fix has been announced.
From public reports: forum.creality.com, forum.creality.com, forum.creality.com · Confirm or add a fix
-
High Extruder motor stops or extruder clogs with no extrusion
Owners report the extruder stopping with no extrusion, including one whose extruder motor stopped entirely with no error even after reseating cables and updating firmware. Others report PETG softening in the extruder gears and clogging.
What fixes it: Creality support offered one owner a replacement motor after receiving videos through live chat. For PETG clogs, owners suggest printing around 230 C and calibrating flow.
From public reports: forum.creality.com, forum.creality.com · Confirm or add a fix
-
Medium Inconsistent first layer from bed warp and noisy bed mesh
Owners see uneven first layers across the large bed. One owner measured about 0.5 mm of bed deformation when hot, and another found repeated probes of the same spot varied by up to about 0.07 mm, about a third of a 0.2 mm layer. That owner also says the firmware ignores the probe samples setting.
What fixes it: Owners have tried heat soaking the bed before probing, a finer mesh, and averaging several mesh runs into a saved mesh. Results are mixed: heat soaking made it worse for one owner and a finer mesh did not help another. One owner reports good results after switching to an aftermarket graphite bed.
From public reports: forum.creality.com, forum.creality.com · Confirm or add a fix
-
Medium Filament cutter does not fully cut, causing jams and FR2865
The toolhead cutter sometimes leaves filament partly attached or with a melted tip, which jams the extruder or triggers FR2865 (filament failed to exit extruder) at the end of a print. One owner tied it to cutter travel tolerance exposed by newer firmware.
What fixes it: Replace the cutter blade, then run the full calibration including cutter calibration. Some owners fit a printed cutter rod spacer, with mixed results.
From public reports: forum.creality.com, forum.creality.com · Confirm or add a fix