Skip to content

Newer version available: the Elegoo Centauri Carbon 2.

Low Open Firmware & Software

Exhaust fan runs during prints and won't turn off

The chamber exhaust fan can spin up during prints and cannot be properly controlled: a community roundup says any non-zero slicer speed becomes 100% and turning it off on the screen resets on the next layer. One owner tied it to firmware 1.1.46.

What fixes it

Owners work around it by setting the filament type to ABS in the profile or repeatedly injecting M106 P3 S0 in the G-code; community OpenCentauri firmware (beta) adds proper control.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment