Elegoo Centauri Carbon known issues
Newer version available: the Elegoo Centauri Carbon 2.
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Low Filament unload/reverse feed fails
On firmware 1.1.42 to 1.1.46 the loader sometimes pushes filament the wrong way or fails to retract, so filament can't be unloaded and color changes fail.
What fixes it: Power cycle the printer, which clears it for that session. Do not roll back to 1.1.25.
From public reports: slickdeals.net, printer-hub.com · Confirm or add a fix
-
Low Exhaust fan runs during prints and won't turn off
The chamber exhaust fan can spin up during prints and cannot be properly controlled: a community roundup says any non-zero slicer speed becomes 100% and turning it off on the screen resets on the next layer. One owner tied it to firmware 1.1.46.
What fixes it: Owners work around it by setting the filament type to ABS in the profile or repeatedly injecting M106 P3 S0 in the G-code; community OpenCentauri firmware (beta) adds proper control.
From public reports: slickdeals.net, printer-hub.com · Confirm or add a fix
-
High Print head USB-C cable fails, causing printhead errors Fixed
The USB-C cable to the print head is bent too tightly and is stretched to its limit when the head travels to the front-left corner, which can damage it over time. Symptoms are intermittent connection and "printhead anomaly detected" errors during homing, leveling or after input shaping. Elegoo has addressed it by offering replacement cables through support.
What fixes it: Request a replacement cable from Elegoo support and add a printed strain relief at the head connector. A temporary 1 m or longer USB-C cable can confirm the diagnosis.
From public reports: help.jaycar.com.au, printables.com, printables.com, slickdeals.net · Confirm or add a fix
-
Medium Clogs when printing PLA/TPU with the lid on
The enclosure holds heat, which can soften PLA and TPU above the melt zone and leads to clogging warnings. Elegoo puts a sticker on the lid telling owners to remove the top cover for PLA and flexible filaments.
What fixes it: Remove the glass lid and keep the door open for PLA and TPU, as Elegoo advises. A vented riser worked for one reviewer on shorter TPU prints.
From public reports: all3dp.com, fabbaloo.com · Confirm or add a fix
-
Low Multicolor add-on delayed; CANVAS retrofit removes the lid Fixed
Elegoo said in November 2025 it could not guarantee a release date for the multicolor add-on and offered owners a filament coupon, extended warranty or a CC2 discount. The CANVAS retrofit later shipped (about $50 to $55), but the glass lid cannot go back on afterward, so the printer is no longer fully enclosed.
What fixes it: CANVAS retrofit is now available; expect an invasive install and plan your own top or enclosure if you print ABS after installing it.
From public reports: tomshardware.com, fauxhammer.com · Confirm or add a fix