Skip to content
Low Open Frame & Structural

PTFE tube knocks against the glass lid

The extruder feed tube arcs high enough to tap the top glass during fast moves, and owners also report it catching the lid handle screws. Reported by one review and by owners in two Reddit threads.

What fixes it

Put a small piece of tape or a soft pad on the tube where it hits, or print the riser listed on QIDI's Printable Components page for the Plus5.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment