QIDI Plus5 known issues
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Medium Uneven bed temperature causes edge warping on large parts
The bed edges run cooler than the center. One review measured up to 8.6 °C of deviation at 60 °C and up to 17 °C at 90 °C and tied it to warped ASA edges; another measured about 6 °C between center and edge at 50 °C and saw slight corner warping on an ABS test cube.
What fixes it: Preheat the chamber before ABS or ASA prints; this removed the corner warping in one review.
From public reports: china-gadgets.de, smartzone.de · Confirm or add a fix
-
Medium No clog detection unless the QIDI Box is connected
3DWork reports that without the optional QIDI Box the printer does not detect filament jams, so a jammed hotend can go unnoticed. A known-issues roundup says QIDI's spec lists tangle detection as requiring the Box.
What fixes it: Adding the QIDI Box adds jam detection, according to 3DWork.
From public reports: 3dwork.io, nikktech.com, printer-hub.com · Confirm or add a fix
-
Medium PLA jams and mushy prints with the lid closed
With the glass lid shut, heat builds in the chamber and PLA softens too early in the hotend, giving mushy prints or full jams. Two independent reviews hit this on PLA shortly after the August 2026 launch, and a known-issues roundup adds owner reports, including one PETG jam in a closed chamber.
What fixes it: Slide the top glass back for PLA; both reviews only got good PLA prints that way.
From public reports: 3dwork.io, china-gadgets.de, printer-hub.com · Confirm or add a fix
-
Low PTFE tube knocks against the glass lid
The extruder feed tube arcs high enough to tap the top glass during fast moves, and owners also report it catching the lid handle screws. Reported by one review and by owners in two Reddit threads.
What fixes it: Put a small piece of tape or a soft pad on the tube where it hits, or print the riser listed on QIDI's Printable Components page for the Plus5.
From public reports: smartzone.de, printer-hub.com · Confirm or add a fix
-
Low Large purge at the start of every print
The machine purges a lot of filament before each print and on load and unload, even without the Box, and 3DWork found no setting on the printer to reduce it. An owner in a Reddit thread called it insanely high and wasteful.
What fixes it: Reduce the purge in the slicer profile. QIDI's firmware 01.01.01.06 reduced purging during print recovery, but not the start-of-print purge.
From public reports: 3dwork.io, printer-hub.com · Confirm or add a fix