Skip to content
Critical Open Electronics & Screen

Nozzle drives into the bed during leveling (strain gauge faults)

During pre-print probing, some printers keep raising the bed until it hits the nozzle, or slam the bed repeatedly, then stop with CM2789 or another error. Owners traced it to a failed strain gauge, pinched toolhead wiring, or a damaged extruder board. One owner had bent guides after the extruder hit the bed.

What fixes it

Replacing the strain gauge and fixing pinched toolhead wires worked for one owner; another saw the fault return after about 20 prints with a new strain gauge. A community member suggests sending support a video with the serial number.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment