Skip to content

Newer version available: the QIDI Plus5.

Low Open Electronics & Screen

Chamber heater trips on prints taller than about 268 mm

On tall prints, the rising bed blocks the chamber heater's outlet at the bottom of the chamber. The heater overheats, thermal protection trips, and Klipper shuts down, ruining the print. The community wiki calls it a hardware design flaw.

What fixes it

Update to firmware 1.6.0 or newer, which largely addresses it. If it still trips, use the community macro that drops the chamber target above 268 mm, with target_min_temp set to 10 so it doesn't conflict.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment