QIDI Plus4 known issues
Newer version available: the QIDI Plus5.
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
Medium PLA and PETG heat creep clogs on first-batch nozzles
A community wiki built from QIDI Discord reports describes a semi-common clog problem on first-batch Plus4 units, mostly with PLA and sometimes PETG, especially on small parts or with lots of retraction. Suspected causes are the first-generation stock nozzle's stainless steel heatbreak and a heatsink fan that is not mounted directly on the heatsink. It does not seem to occur with higher-temperature filaments.
What fixes it: The community wiki reports that QIDI's nozzle with a ceramic (white) heatbreak appears to work, along with a printed heatsink duct and a stronger heatsink fan. Raising nozzle temperature 5 to 10 °C helps but does not fully stop the clogs. QIDI has not announced a fix for first-batch units.
From public reports: github.com · Confirm or add a fix
-
Low Weak stock cooling for mainboard and stepper drivers
The Plus4's small rear fan barely cools the mainboard and stepper drivers, so owners have designed several replacement fan covers and ducts. The community wiki also carries an adaptive mainboard cooling config.
What fixes it: Fit a printed duct or larger fan cover over the drivers and CPU.
From public reports: printables.com, printables.com, github.com · Confirm or add a fix
-
Low Chamber heater trips on prints taller than about 268 mm
On tall prints, the rising bed blocks the chamber heater's outlet at the bottom of the chamber. The heater overheats, thermal protection trips, and Klipper shuts down, ruining the print. The community wiki calls it a hardware design flaw.
What fixes it: Update to firmware 1.6.0 or newer, which largely addresses it. If it still trips, use the community macro that drops the chamber target above 268 mm, with target_min_temp set to 10 so it doesn't conflict.
From public reports: github.com, 3dprint.com · Confirm or add a fix
-
Critical Chamber heater relay overheating on early 120 V units Fixed
On early Plus4 units in 120 V regions, the solid-state relay board that switches the chamber heater could overheat and melt, raising fire concerns. It was raised publicly in late 2024. QIDI lowered the heater's maximum power in firmware and shipped a redesigned relay board free to affected owners; units built after about December 2024 should already have it.
What fixes it: Install the latest firmware (QIDI reduced the heater's maximum power) and ask QIDI support for the redesigned relay board if you have an early 120 V unit built before about December 2024.
From public reports: 3dprint.com, github.com, github.com, github.com · Confirm or add a fix