Skip to content
Critical Fixed Electronics & Screen

Power board inrush thermistor can overheat and melt plastic

On the original AC power distribution board, the NTC inrush-current thermistor can fail and run very hot, softening nearby parts and in some reported cases melting the printer's plastic housing. Bambu says failures are rare (about 0.05%), tied mostly to power surges, and that the part was removed and the board redesigned in Q3 2025. No fires were reported, but it drew wide attention in late 2025.

What fixes it

Affected owners get a replacement power board from Bambu support, in or out of warranty. Bambu recommends a surge protector. Units built after Q3 2025 use the redesigned board.

Log in to confirm this happens to you 0 owners confirmed

Workarounds (0)

No workarounds posted yet.

Comments (0)

No comments yet.

Log in to comment