Bambu Lab A1 known issues
What owners run into, most important first. Issues marked "from public reports" come from brand advisories, owner forums and reviews, linked on each one.
-
High Filament blob encases hotend and breaks thermistor wires
A detached print can let molten filament wrap the nozzle, heater and wiring into a blob. The exposed thermistor and heater wires on the A1 hotend are easily damaged, by the blob or during removal. One owner could not reach any screws to remove the encased hotend; another found the hotend would not heat after removing a blob, and a replacement hotend did not fix it.
What fixes it: Good bed adhesion reduces the risk. Remove blobs slowly while the nozzle is hot and keep clear of the wires. Damaged wiring needs a replacement hotend heating assembly, and possibly further parts from support.
From public reports: forum.bambulab.com, forum.bambulab.com · Confirm or add a fix
-
Low Asks to load and purge filament that is already loaded
Since the June 2026 firmware update, A1 and A1 Mini owners say the first print after the printer sits cold acts as if new filament was just loaded: it asks for confirmation, then pushes and purges filament before starting. It wastes filament and means walking to the printer to press continue. Owners say rolling back firmware stops it.
What fixes it: Roll back to the previous firmware. One owner fixed it by setting AMS type to "AMS 2 / H2D (Hermes)" with no AMS attached. One A1 owner says firmware 01.09.00.00 (Nov 9, 2026) fixed it; not yet confirmed by others.
From public reports: forum.bambulab.com, forum.bambulab.com · Confirm or add a fix
-
Low Firmware authorization blocks third-party printer control
Bambu's authorization control firmware requires approved software to start prints and control the printer. On updated A1 firmware, third-party tools that sent jobs or controlled the printer directly stop working unless the printer is put in LAN-only Developer Mode. Status reporting and SD card printing are unaffected.
What fixes it: Enable LAN Only mode plus Developer Mode, use Bambu Connect, or stay on older firmware.
From public reports: blog.bambulab.com, feedback.simplyprint.io · Confirm or add a fix
-
Critical Power board inrush thermistor can overheat and melt plastic Fixed
On the original AC power distribution board, the NTC inrush-current thermistor can fail and run very hot, softening nearby parts and in some reported cases melting the printer's plastic housing. Bambu says failures are rare (about 0.05%), tied mostly to power surges, and that the part was removed and the board redesigned in Q3 2025. No fires were reported, but it drew wide attention in late 2025.
What fixes it: Affected owners get a replacement power board from Bambu support, in or out of warranty. Bambu recommends a surge protector. Units built after Q3 2025 use the redesigned board.
From public reports: all3dp.com, tomshardware.com, forum.bambulab.com · Confirm or add a fix
-
Critical Heatbed cable recall over electrical and fire risk Fixed
In early 2024 Bambu found damage near the heatbed cable connector on some A1 units that could cause electrical failure, with at least one owner reporting the cable burning. Bambu first issued a callback in late January 2024, then extended it on Feb 4, 2024 to every A1 sold and asked owners to stop using them. Fewer than 0.1% of units had reported damage.
What fixes it: Bambu offered a full refund or a replacement heatbed with a revised cable (about a 20 minute swap), plus store credit and extra warranty. Later production units ship with the revised cable.
From public reports: blog.bambulab.com, forum.bambulab.com · Confirm or add a fix