Inconsistent first layer from bed warp and noisy bed mesh
Owners see uneven first layers across the large bed. One owner measured about 0.5 mm of bed deformation when hot, and another found repeated probes of the same spot varied by up to about 0.07 mm, about a third of a 0.2 mm layer. That owner also says the firmware ignores the probe samples setting.
What fixes it
Owners have tried heat soaking the bed before probing, a finer mesh, and averaging several mesh runs into a saved mesh. Results are mixed: heat soaking made it worse for one owner and a finer mesh did not help another. One owner reports good results after switching to an aftermarket graphite bed.
Log in to confirm this happens to you
0 owners confirmed